Gibson GNGJ60JGUC Uživatelský manuál stáhnout pdf (Strana 22)

1. Unscrew approximately one turn the

bypass screw position A.

2. Put the knob for the hob back.

3. Connect the appliance to the electricity.

WARNING!

Put the mains plug into the

mains socket only if all parts

are back into their initial

position. There is a risk of

injury.

4. Light the burner.

Refer to "Hob - Daily use" chapter.

5. Turn the knob for the hob to the minimum

position.

6. Remove the knob for the hob again.

7. Screw on slowly the bypass screw till the

flame becomes minimum and stable.

8. Put the knob for the hob back on.

Oven injector replacement

1. Remove the bottom plate of the oven

cavity to get access to the oven burner .

2. Carefully remove from the burner the

thermocouple A. Next remove the spark

plug B.

A

B

3. Unscrew the screw and slowly pull out the

burner.

1

2

4.

Release the burner injector with a 7 mm

socket spanner and replace it with a right

one.

Assemble the burner in a revers sequence.

Replace the gas type sticker near the gas

supply ramp with the one related to the new

gas type.

Adjusting the minimum gas level on the

oven burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the oven functions.

If there is no access to the bypass screw

dismount the control panel before

adjustment start.

3. With a thin and flat screwdriver adjust the

bypass screw A.

The model determines the position of the

bypass screw A.

A

A

22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Komentáře k této Příručce

Žádné komentáře